ASTi Telestra User's Guide download pdf (Page 211)

ASTi Telestra User Guide (Ver. 2, Rev. L.1)

Telestra version 2.1, September 2002

• New: Telestra 2.1 adds RMS support for the ASTi high-frequency (HF) radio propagation

server with ALE support, satellite communications server, panel state machine runtime

environment, and ASTi’s new USB I/O device for panel interface to state machines.

• New: Telestra 2.1 adds HLA support for DMSO HLA RTI 1.3NGv6 and MÄK HLA RTI

1.3.7.

• New: The Model Documentation Tool uses a newer, high-performance XML parser which

greatly reduces the amount of time required for PDF generation.

• New: DACS system information screens include the amount of free and used memory for

each system. DACS systems can now be explicitly rebooted.

• Change: The default IP address for Telestra network interface eth2 has changed; it is now

20.1.1.1.

• Change: The Telestra Conﬁguration File formats for DACS host, terrain and tactical data

link server IP addresses has changed. Previously-generated “telestra.conf” ﬁles containing

the old format must be changed to work with version 2.1. In the following table, “dacsX”

would correspond directly to a DACS system previously conﬁgured for RMS management,

e.g., “dacs1”, “dacs2”, etc. The “xxx.xxx.xxx.xxx” portion would represent a correct and

valid IP address for the associated server.

Table 9: Changes to the Telestra Conﬁguration File for DACS Server Routing

• Fixed: The ICD offsets have been ﬁxed in the Model Documentation Tool.

• Fixed: A seven second waiting period is introduced on DACS restart after loading a differ-

ent conﬁguration ﬁle. This keeps RMS from returning a “DACS not responding” error in the

event the DACS is restarting (MB not running) when the system is polled.

• Broken: The “RestartOff” state in the Model Builder software (e.g., during model editing)

does not affect RMS’ ability to attempt to load a new “.cfg” ﬁle. If in “RestartOff” mode, a

DACS will not restart with the speciﬁed conﬁguration ﬁle, although it will appear to do so

in RMS. Only after Model Builder comes out of the “RestartOff” state will it load the RMS-

speciﬁed conﬁguration ﬁle and restart. Model Builder loads with “RestartOn” by default.

Old Format New Format

hla:dacsX:host:xxx.xxx.xxx.xxx route:dacsX:host:xxx.xxx.xxx.xxx

hla:dacsX:terrain:xxx.xxx.xxx.xxx route:dacsX:terrain:xxx.xxx.xxx.xxx

hla:dacsX:tdl:xxx.xxx.xxx.xxx route:dacsX:tdl:xxx.xxx.xxx.xxx

1 2 ... 206 207 208 209 210 211 212 213 214

No comments

ASTi Telestra User's Guide Page 211