ASTi Telestra User's Guide download pdf (Page 152)

ASTi Telestra User Guide (Ver. 2, Rev. L.1)

Chapter 15: USB I/O Device Software Conﬁguration

Software Conﬁguration

See your system documentation for USB I/O device hardware speciﬁcation, installation proce-

dures, etc. The following software conﬁguration is also included in that document.

To utilize ASTi USB I/O devices in conjunction with the Panel State Machine Runtime Environ-

ment, the system software must be conﬁgured to associate each device’s serial number (embedded

in its ﬁrmware) with a functional software label (e.g., “Pilot”, “Copilot”, etc.).

This procedure integrates a speciﬁc USB I/O device with a speciﬁc instance of the panel state

machine. The procedure must be performed at system initialization, and whenever a USB I/O

device is replaced. Labels and associated serial numbers are stored in the USB hardware conﬁgu-

ration and mapping ﬁle on Telestra.

USB I/O device conﬁguration is made easy through utilities available via the Telestra RMS web

interface. The following discussion describes the basic USB I/O device conﬁguration procedure.

Using a web browser, access RMS and select the Telestra connected to the USB devices to be con-

ﬁgured.

1 Click the “USB” link in the RMS menu.

2 For each USB I/O device in the hardware conﬁguration and mapping ﬁle, RMS will dis-

play its serial number, label, IP address, ﬁrmware version, and other information.

3 RMS will automatically detect plugged-in USB I/O devices, and compare them to the

hardware conﬁguration and mapping ﬁle. It will display the status of each: Plugged-in and

Conﬁgured (green status), Plugged-in and Not Conﬁgured (yellow status), or Conﬁgured

but Not Plugged-in (red status).

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 213 214

No comments

ASTi Telestra User's Guide Page 152