ASTi Telestra Service Manual Page 206
- Page / 248
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
DOC-01-TELAS-CRG-4 ASTi ACE Studio Components Reference Guide Rev.M
196 Copyright © 2014 Advanced Simulation Technology inc.
15.7. MorseKeyer
Summary: The MorseKeyer component is used to create a 4-letter morse code
sequence.
Description: The MorseKeyer component is used to translate 4 letter words into
Morse Code. The component allows control over the wordrate, interval and the fre-
quency (pitch) of the generated tone. In addition to the usual letters and numbers
defined in Morse code, it also includes the characters ‘*’ and ‘-’ to represent indi-
vidual dot and dash combinations.
Control Inputs
Enable
Type Default Value
boolean True
Description: When True it enables the Morse Keyer. When False
the Morse Keyer is disabled.
Frequency
Type Default Value
float32 1.0
Description: Provides the frequency (pitch) of the Morse tone.
Units are in Hertz.
Gain
Type Default Value
float32 1.0
Description: Scales the strength of the generated tone.
Ident
Type Default Value
ident n/a
Description: The 4-letter word that connects into Morse code. Ident
is a special variable Type which is defined as 4 ASCII characters
concatenated together. A HostIn component must be used to drive
this parameter.
Control Inputs
Interval
Type Default Value
uint16 1
Description: The total cycle in seconds before the ident message
starts playing including the pause. i.e. The wordrate time plus the
pause after the ident message (wordrate - interval) before a new
cycle begins. Interval number must be larger than the wordrate.
ILSPause
Type Default Value
boolean False
Description: When False, MorseKeyer uses normal Morse code
inter-character timing which is a three (3) dot gap between all ident
characters. When True, MorseKeyer uses a standard morse code
inter-word timing between the first and second characters (i.e. a
seven (7) dot gap). Inter-character timing for subsequent ident char-
acters will use standard Morse code inter-character spacing (i.e. a
three (3) dot gap).
Wordrate
Type Default Value
uint8 1
Description: Determines the rate at which the word is keyed.
Audio Output
OutSignal
Type Default Value
audio/audio n/a
Description: Outputs the keyed word when the PTT control is
enabled.
- Telestra 4 1
- ACE Studio Components 1
- Reference Guide 1
- Document: DOC-01-TELAS-CRG-4 1
- Table of Contents 5
- 1.0. Introduction 11
- 2.0. Audio Components 13
- 2.1. AmpMod 14
- Type Default Value 15
- 2.2. Audio Feed 16
- 2.3. AutoDred 17
- 2.4. Complex Playsound 22
- 2.5. Compressor 24
- XOutSig 28
- 2.6. Delay 29
- 2.7. Demux 30
- 2.8. Envelope 31
- 2.9. Filter 33
- 2.10. Lockout 36
- 2.11. Level D Capture 38
- 2.12. MessageList 40
- 2.13. Mixer 42
- 2.14. Noise Source 44
- 2.15. PEnvelope 47
- 2.16. PFilter 48
- 2.17. Playsound 49
- 2.18. Pulse 51
- 2.19. Pulse Sequence 53
- 2.20. PulseStep 56
- 2.21. PulseStream 59
- 2.22. Record Replay 64
- 2.23. SimpleMixer 68
- 2.24. Sequencer 69
- 2.25. Volume Control 71
- 2.26. Vox 72
- 2.27. Wave 75
- 3.0. AudioIO 78
- 4.0. Comm Panel 79
- 4.2. CommPanel8Stereo 83
- 4.3. Stereo Comm Panel 86
- 5.0. Control Components 88
- 5.2. ByteToBit 89
- 5.3. ByteMerger 90
- 5.4. Byte Splitter 92
- 5.5. Counter 94
- 5.6. Delay 97
- 5.7. Ident 98
- 5.8. Incrementer 99
- 5.9. IntCompare 100
- 5.10. IntTable 102
- 5.11. Latch 103
- 5.12. LogicTable 104
- 5.13. MathFunction 106
- 5.12. NumToString 108
- 5.13. PassThrough 110
- 6.0. Dynamics 111
- 6.1. AGC 112
- 6.2. CompressorLimiter 114
- 6.3. Expander 116
- 6.4. Gate 118
- 7.0. Environmental Cue 120
- 7.2. Engine 123
- 7.3. Engine Level D 126
- 7.4. MultiFilter 128
- 7.5. Prop Rotor 131
- 7.6. Vibration Capture 133
- 8.0. Highway Service 134
- 8.1. AuralCue 135
- 8.2. AuralCuePosn 136
- 8.3. SpeakerOutput 137
- 9.0. Highway 3D Service 138
- 9.1. Audio > Audio Feed 141
- 9.5. AudioIO > HighwayOut 145
- 9.6. AudioIO > SpeakerOut 146
- 10.0. HRTF Service 147
- 10.1. HRTFOut4 148
- 10.2. CommPanel8HRTF4 150
- 11.0. IOInterfaces 152
- 11.2. ACE_RIU_SerialByteOut 154
- 11.3. ACUchannel 155
- 11.4. ACU2channel 158
- 11.5. ACU2_SerialByteOut 161
- 11.6. AmpOut 162
- 11.7. SerialPort 163
- 11.8. VoisusChannel 164
- 12.0. Intercoms 167
- 12.2. IcomTx 169
- 12.3. Intercom Bus Power 170
- 12.4. Intercom Bus Service 171
- 13.0. Platform 172
- 13.1. Detonation 173
- 13.2. Fire 173
- 13.3. Geocentric Position 174
- 13.4. Geodetic Position 175
- 13.5. Relative Position 176
- 14.0. Host Control 181
- 14.2. Host Out 185
- 14.3. Cell Service 186
- 14.3.2. CellOut 188
- 15.0. Radio Components 189
- 15.1. ColocatedBeacon 190
- 15.2. Generic Control 193
- 15.3. HFServer 196
- 15.4. Intercom Transceiver 198
- 15.5. ICU 201
- 15.6. MarkerTone 202
- 15.7. MorseKeyer 206
- 15.8. RCUbasic 208
- 15.9. Receiver 210
- 15.10. Relay 212
- 14.11. Satellite 215
- 14.12. Transceiver 219
- 14.13. Transmitter 230
- 14.14. VORTAC_Controller 232
- 15.0. Speech 234
- 15.2. TextToSpeech 235
- 16.0. Remote Control 236
Related products and manuals for Recording Equipment ASTi Telestra
Recording Equipment ASTi Telestra User's Guide
(166 pages)
(166 pages)
Recording Equipment ASTi Telestra User's Guide
(214 pages)
(214 pages)
Recording Equipment ASTi Telestra Service Manual
(119 pages)
(119 pages)
© 2020, manymanuals.com. All rights reserved. | 0.700 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals