ASTi Telestra Service Manual download pdf (Page 16)

ASTi Telestra 4 Target Operations & Maintenance Manual (Ver. 1, Rev. K)

3.3. Software Installation and Configuration

Targets are shipped with all necessary software pre-installed. To rebuild the system’s hard disk,

reference the Telestra 4 Target Cold Start Procedure (DOC-02-TEL4-TCS-1). Turn on the Target

via the power switch on the front of the chassis. The system will boot into the Linux operating

system. For further instruction on Target installation, please see the Telestra 4 Quick Start Guide

(DOC-01-TEL4-QSG-1) for initial setup and IP address assignment.

The only user account that exists after system installation or cold start is “admin” (without the

quotes). The default password for this user is also “admin.” All user account logins and passwords

are case-sensitive.

3.3.1. Network Ports

Each Target has three or more Ethernet network ports depending on the system configuration. The

physical location and function of each of these connections varies, based on the hardware

installed by ASTi prior to shipment. The connections will vary over time and from system to

system. Please read the ETH labels on your system to verify Ethernet locations.

The multiple network ports provide convenient, independent connection to a DIS or HLA

network, Host simulation network, Diskless, and ACENet. The local or host network is used to

pass required data and state parameters back and forth to the user defined sound and

communications models on the Target and the customer's simulation software.

PROPERTY OF

ASTI

0000

Network Ports

See chassis labels for ethernet assignment

Ethernet labels will be Eth0, Eth1, and Eth2

Figure 4: Network Ports

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 42 43

No comments

ASTi Telestra Service Manual Page 16