ASTi Telestra Service Manual download pdf (Page 14)

ASTi Telestra 4 Quick Start (Ver. 1, Rev. E)

3.0. Setting up the Telestra 4 Target

To complete the set up you will need the following hardware:

• monitor

• keyboard

• ACE Studio Development Workstation

• Category 5e cable or better

• Target

Follow the steps below to setup the Target and assign an IP address.

1. Connect the monitor and keyboard to the Target.

2. Using a Category 5e cable, connect the Target to the ASTiNet/DIS network using Eth0.

See “Top Level Hardware Layout” on page 1.

3. Power on the Target and allow it to boot.

4. Login with the following:

Username: root Password: abcd1234

5. The Target will not have an IP address without a DHCP network connection. To set an IP

address, type:

ace-net-config -a xxx.xxx.xxx.xxx -n yyy.yyy.yyy.yyy

where ‘x.x.x.x’ is the IP address and ‘y.y.y.y’ is the subnet mask.

This sets the IP address and netmask for Eth0 which is used to access the Remote Man-

agement System (RMS) via a web browser.

6. Optional: For more network setup options type:

ace-net-config -h

7. Once you have configured Eth0, you can use RMS to make additional changes to the net-

work settings.

8. On the development workstation or any computer on the network with a web browser,

open a browser and in the address bar type in the IP address to open the Remote Manage

ment System (RMS).

Note: Depending on your web browser and browser version, the browser may show a

failed connection due to a self signed security certificate. Bypass the warning by following

the prompts to add a security exception.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

ASTi Telestra Service Manual Page 14